Should You Cover Firewood? Tarps and Covers Guide

Should you cover firewood before the rain arrives? Short answer: yes, cover the top of the stack and leave the sides open. Rain soaks the top rows fast, and wet wood burns poorly, smokes more, and builds up creosote in the chimney. A cover keeps the rain off while air keeps drying the wood underneath.

This guide walks you through the cover decision for each season, the tarp and cover types that work best, and the mistakes that trap moisture instead of keeping it out. You will learn how to fit a cover, fasten it against wind, and know when to pull it back so sun and wind can finish the drying. The method works for a small backyard stack and a full winter supply.

Plan on about 30 minutes to measure, fit, and fasten a cover on a typical stack, plus a quick monthly check through the season. The work is light and needs no special skill. Read the safety note below before you start, then gather the items in the list and work through the steps in order.

Heads Up: Burn Dry Wood Only

Burn dry wood only. Wet wood burns cooler, makes more smoke, and leaves more creosote in the flue, which raises chimney fire risk. Have the chimney inspected and swept each year by a certified sweep, and never burn treated, painted, or stained wood.

Check local burn rules and firewood transport rules before you move wood, since some areas limit movement to slow the spread of pests. The EPA Burn Wise program has plain guidance on clean burning.

Total Time
About 30 minutes
Active Time
About 30 minutes
Difficulty
Beginner
Upkeep
5 minutes a month
What You Need
  • Tarp or fitted firewood cover
  • Bungee cords or rope
  • Bricks or sandbags
  • Tape measure
  • Moisture meter
  • Pallets or rails to raise the stack
  • Work gloves
  • Broom for snow

Should You Cover Firewood All Year?

Yes, keep a top cover on the stack through most of the year. Rain and snow soak exposed wood, and a wet top layer can take weeks to dry again. Pull the cover back on dry, breezy days so sun and wind can reach the wood.

The exception is fresh, green wood in hot, dry weather. Green wood dries best with full sun and wind on all sides, so leave it uncovered during a dry spell and cover it before rain. Once the wood reads below 20 percent on a moisture meter, keep the top covered and the sides open. Learn how to tell if firewood is seasoned before you trust the reading.

Weather or SeasonCover or Leave OpenWhy
Heavy rain or snowCover the top, sides openRain soaks the top rows fast
Dry, breezy weekPull the cover backSun and wind pull out moisture
Green wood in summerLeave open in dry weatherFull air flow dries green wood fastest
Wood ready to burnKeep the top coveredDry wood stays ready through storms

How a Cover Changes Moisture and Air Flow

A cover works by blocking rain and snow from above while air moves through the open sides. Air flow carries moisture out of the wood, so a stack dries from the sides even while the top stays dry. A cover that hangs to the ground blocks that air flow and traps damp air inside.

That trapped damp air is the real risk. Wood under a sealed tarp can stay damp for months and grow mold on the bark and ends. Moldy wood smells stale, burns poorly, and can bother people with allergies or asthma. Keep the sides open and the problem stays small.

Cover choice matters less than air flow, but a good fit helps. Our guide to how to store firewood outside covers stack height, ground clearance, and spacing in more detail. Our guide to how to stack firewood shows how to build a level top row that sheds water well. Pair that advice with the steps below and the stack stays dry and ready to burn.

Cover ChoiceRain ProtectionAir FlowBest For
Heavy tarpGoodGood, when top onlyMost stacks, low cost
Fitted firewood coverGoodGood, when top onlyStandard racks
Wood shed or roofBestBest, open sidesLarge winter supply
No coverPoorBestGreen wood in dry spells only

How Long a Firewood Cover Lasts

Sun breaks down tarp fabric over time, so a cover will not last forever. A light tarp may tear after a single season of strong sun, while a heavy tarp can last several seasons. Check the seams and grommets each autumn before the rain returns, and replace a cover that has torn or gone stiff.

Store the cover dry over summer if the stack runs empty, since a folded, dry tarp lasts longer than one left out in the weather. Shake off dirt and leaves before you fold it, and keep it out of reach of mice, which chew fabric for nesting. A cover that still sheds water and ties down tight is good for another season.

At a Glance
  1. Check the Moisture Before You Cover
  2. Measure the Stack Before You Buy a Cover
  3. Cover Only the Top of the Stack
  4. Pick a Tarp or Cover That Fits the Stack
  5. Fasten the Cover So Wind Cannot Lift It
  6. Uncover the Top Rows on Dry, Breezy Days
  7. Inspect the Stack Each Month Through Winter

Check the Moisture Before You Cover

Press the pins of a moisture meter into the split face of a log from the top row. A reading below 20 percent means the wood is ready to burn and safe to keep covered.

A higher reading means the wood still needs sun and wind, so leave it uncovered until the next dry spell. If the reading stays high for weeks, read our guide on how to season firewood. Note the reading and date on paper taped to the stack.

Hand holding a moisture meter against split firewood to check the wood is dry before deciding should you cover firewood
Test the top rows with a moisture meter before you fit a cover.

Measure the Stack Before You Buy a Cover

Run a tape measure across the top of the stack and down each side. Add about 6 inches of overhang on each side so rain drips clear of the wood instead of running down the face of the stack. A cover that ends flush with the wood lets rain run straight onto the top rows.

Cover Only the Top of the Stack

Lay the tarp across the top of the stack and let it hang a few inches down each side. Keep the sides open so air can move through the rows and carry moisture away.

Resist the urge to wrap the whole stack. A tarp that reaches the ground traps damp air, and damp air grows mold and slows drying. If wind keeps lifting the edges, add weights or cords at the top instead of pulling the tarp lower.

Firewood stack with a tarp covering only the top beside a fully wrapped stack, showing why you should cover firewood from above only
Cover the top only, as shown on the left. A full wrap traps damp air inside the stack.

Pick a Tarp or Cover That Fits the Stack

A heavy polyethylene tarp works for most stacks and costs less than a fitted cover. Choose a tarp with grommets along the edges so you can tie it down without tearing the corners. A fitted firewood cover suits a standard rack, since it stays in shape and sheds water well. Check the seams and grommets each season and replace a cover that has torn or gone stiff in the sun.

A dark tarp warms in the sun and helps melt light snow off the top. A light tarp shows dirt less and stays cooler in summer.

Fasten the Cover So Wind Cannot Lift It

Thread a bungee cord or rope through the grommets and tie it to the rack or to the bottom rows of wood. Pull the cord snug, but leave slack enough that the tarp can shift a little in a gust without tearing. Bricks or sandbags on the top corners work as well, and they make it quick to lift the cover on a dry day.

Uncover the Top Rows on Dry, Breezy Days

Fold the cover back over half the stack when the forecast shows two or three dry, breezy days. Sun and wind reach the exposed rows and pull out moisture that rain left behind. This habit matters most in spring, when damp wood needs every dry day it can get.

Cover the stack again before rain returns. A quick check of the forecast each evening takes a minute and saves a wet top layer. If the wood is already below 20 percent, you can leave the top covered through a dry spell and skip this step.

Inspect the Stack Each Month Through Winter

Lift a corner of the cover once a month and look at the top rows. Sniff for a stale, musty smell and look for dark mold spots on the bark or cut ends. Pull out any moldy pieces and let them dry apart from the stack, then refasten the cover. A five minute check catches a damp patch before it spreads through the whole stack.

Troubleshooting: Cover Problems and Fixes

If This HappensTry This
Tarp blows off in windTie through grommets with bungee cords and add weights on the corners
Mold grows under the coverPull the cover back on dry days and leave the sides open for air flow
Top rows stay wet after rainCheck the overhang and replace a torn cover that lets water through
Wood smells mustyMove damp pieces out to dry apart and check the stack each month
Snow piles on the coverBrush snow off with a broom so the weight does not sag the tarp onto the wood

Frequently Asked Questions

Should you cover firewood in the summer?

Yes, cover the top before rain, and pull the cover back during dry, sunny spells. Green wood dries faster with sun and wind on all sides. Once the wood tests below 20 percent, keep the top covered and the sides open.

Is it better to cover firewood or leave it uncovered?

Cover the top and leave the sides open, since that mix keeps rain off while air keeps drying the wood. A fully uncovered stack soaks in every storm. A fully wrapped stack traps damp air and grows mold.

Should you cover firewood with a tarp?

Yes, a heavy tarp with grommets works well when it covers only the top. Let it hang a few inches down each side and tie it through the grommets. Replace a tarp that has torn or gone stiff in the sun.

Does covering firewood stop it from drying?

A top cover does not stop drying, since the open sides let air move through the rows. A cover that wraps the whole stack does slow drying and can trap moisture. If the wood still tests wet, our guide on how to dry firewood fast lists safe ways to speed the process.

When should you uncover firewood?

Uncover the top rows on dry, breezy days so sun and wind can reach the wood. Cover the stack again before rain returns. In spring, use every dry spell to pull out moisture left by winter storms.

Quick Reference Card
What You Need
  • Tarp or fitted cover, bungee cords or rope, bricks or sandbags
  • Tape measure, moisture meter, pallets or rails, work gloves, broom
Steps
  1. Check the moisture and cover only wood below 20 percent.
  2. Measure the stack and add 6 inches of overhang per side.
  3. Cover the top only and leave the sides open.
  4. Pick a tarp with grommets or a fitted cover.
  5. Fasten the cover with cords or weights.
  6. Uncover the top rows on dry, breezy days.
  7. Inspect the stack once a month through winter.

Final Word

Cover the top, leave the sides open, and check the stack each month. That is the whole method, and it answers should you cover firewood with a clear yes, done the right way. Your next step is to measure the stack and fit a cover before the next storm, and our guide to how much firewood you need for winter can help you plan the full season.

Dry wood lights faster, burns hotter, and leaves less creosote behind. The small effort of fitting a cover pays off each time you carry in an armload of dry logs.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *